Replacement Controller for a Compatible DR-HO’S Circulation Promoter
A replacement control module for the compatible DR-HO’S Circulation Promoter system. It provides access to the device’s intensity, mode and timer controls when connected to the correct foot base or compatible electrode accessory.
Adjustable Intensity
The dial allows stimulation intensity to be increased gradually to a comfortable level.
Three Modes
Select between the A, B and C stimulation patterns shown on the controller.
Session Timer
Choose a 10, 20 or 40-minute setting using the front timer button.
Check the Connection
This listing shows the earlier 3.5mm-style top socket. Compare your wire before ordering.
DR-HO’S Circulation Promoter Control Module
This replacement control module is intended for a compatible DR-HO’S Circulation Promoter system. It replaces the handheld controller component used to select the stimulation mode, session duration and intensity.
The module can be connected to the correct Circulation Promoter foot base or to compatible DR-HO’S body-pad accessories using the appropriate lead wire. It does not operate as a complete therapy system by itself.
This product is the control module only. The foot platform, base lead wire, body-pad wire, gel pads, sleeves and batteries are not included unless specifically stated elsewhere on the product page.
Simple Front-Panel Controls
The replacement unit uses physical controls for straightforward operation and adjustment.
Intensity Dial
The upper dial combines the on/off function with adjustable stimulation intensity. Always begin at the lowest setting.
Mode Selection
Press the Mode button to move between the A, B and C stimulation patterns displayed by the indicator lights.
Modes A / B / CTimer Selection
Press the Time button to choose a 10, 20 or 40-minute session setting, shown by the corresponding indicator light.
Confirm the Socket Before Ordering
DR-HO’S Circulation Promoter generations use different base-wire connections. The plug must match the socket on the replacement controller.
3.5mm-Style Top Socket
V1 BASE WIRE STYLEThe product photos show the earlier controller with a round 3.5mm-style socket on the top edge. This connection is used with the compatible V1-style base lead wire.
Yellow CE Socket
V3 WIRE IS DIFFERENTLater Circulation Promoter controllers can use a yellow CE-style top connection and a V3 base wire. That connection is different from the module pictured in this listing.
Before ordering: compare the top socket, side connection, battery compartment and front control layout with your original module. Do not force an incompatible plug into the controller.
Key Features
- Replacement controller for a compatible DR-HO’S Circulation Promoter
- Physical on/off and intensity dial
- Three selectable stimulation modes: A, B and C
- Selectable 10, 20 and 40-minute timer settings
- Front indicator lights for mode and timer selection
- Two-AAA battery compartment
- Can connect to a compatible foot base or body-pad accessory using the correct wire
- Control module only — accessories and batteries are not included
Best Suited For
- Replacing a lost or damaged compatible Circulation Promoter controller
- Customers who already own the matching foot platform and lead wire
- A module with a worn intensity dial or unreliable buttons
- A controller with a damaged battery compartment or connection socket
- Keeping a compatible spare control module available
- Restoring control of an otherwise complete Circulation Promoter system
What’s Included
This is a replacement component, not the complete Circulation Promoter package.
1 × DR-HO’S Circulation Promoter Control Module
Foot platform, base wire, body-pad wire, gel pads, sleeves, batteries and other accessories are not included.
How to Set Up the Replacement Controller
Read the Circulation Promoter instructions before connecting or operating the replacement module.
1. Check Compatibility
Confirm that your lead-wire plug matches the controller socket shown in the product photos.
2. Install Batteries
Install two fresh AAA alkaline batteries in the orientation marked inside the compartment.
3. Connect the Accessory
With the dial switched off, insert the correct base or body-pad lead wire fully and gently.
Do Not Force4. Start at Minimum
Select the mode and timer, then increase intensity slowly from the lowest setting.
Looking After the Control Module
Keep the controller, battery compartment and sockets clean, dry and protected from strain.
Use Matching Batteries
Use two fresh AAA alkaline batteries of the same brand and age. Do not mix old and new batteries.
Remove for Storage
Remove the batteries if the module will not be used for an extended period to reduce leakage risk.
Keep Dry
Do not immerse the module or allow water, conductive gel or cleaning liquid to enter the sockets.
If the System Does Not Operate Correctly
A connection, battery or electrode-contact issue can sometimes appear to be a controller fault.
No Power
Check battery orientation, install fresh AAA alkaline batteries and confirm the compartment contacts are clean.
No Stimulation
Confirm the correct wire is inserted fully and that feet or compatible electrodes have proper contact.
Uneven Sensation
Reduce intensity and check foot moisture, gel-pad condition, electrode placement and all connections.
Circulation Promoter Control Module FAQ
Quick answers about compatibility, batteries, controls and included components.
Is the foot platform included?
No. This listing is for the replacement control module only.
Is a base lead wire included?
No. The correct compatible base lead wire must already be owned or purchased separately.
What batteries does it use?
The module uses two AAA alkaline batteries. Batteries are not included.
Will it fit every Circulation Promoter?
No. Different generations use different base-wire sockets. Compare the product images with your original controller.
Can it be used with body pads?
It may be used with compatible DR-HO’S body pads when connected with the correct matching lead wire.
What timer settings are available?
The front panel provides 10, 20 and 40-minute timer selections.
Important Use & Safety Information
Do not use this electrotherapy controller if you have a cardiac pacemaker, implanted defibrillator or another implanted electronic device.
Do not use during pregnancy or on small children. Consult a healthcare professional before use if you have a medical condition, reduced sensation, circulation concerns or uncertainty about whether electrotherapy is suitable for you.
Use only with compatible DR-HO’S accessories and the correct lead wires. Never force plugs into sockets or use damaged, wet, frayed or loose wires.
Begin every session at the lowest intensity. Stop use if stimulation is painful or if unusual discomfort, burning, dizziness, skin irritation or another unexpected reaction occurs.
This replacement module is not a substitute for professional medical advice or care. Read and follow the original Circulation Promoter instructions before use.
* This device must NOT be used on people with Cardiac Pacemakers, implanted defibrillators or other electronic devices.
* Do not use if you are pregnant and not suitable for small children.
* This device is not intended as a substitute for professional medical care nor is this a medical device suitable for all people.
* As with any new product, always consult your medical practitioner, especially if you have pre – existing conditions.
* All instructions should be read carefully before using this device.
Orders over $100 shipping is free.
Standard Shipping $9.95 for orders under $100.
2 - 7 days delivery time depending on your location from Southport QLD.
Express delivery $24.95.
1 - 3 days delivery time depending on your location from Southport QLD.
Same day dispatch if you order before 1pm.
You can choose your shipping option at checkout. All orders are posted fully insured and a signature is required on delivery.
Customer pick up is available from our Southport store.
